VHF S-meter (FULL) adjustment
1. In the adjustment mode, select channel 13 by rotating the main tuning dial.
The S-meter will show all circles ( )
2. Enter ?+20?? (E dBMF) with the transceiver tester (SSG).
3. Press the key. The transceiver beeps indicating the new setting has
been stored successfully.
UHF S-meter (1) adjustment
1. In the adjustment mode, select channel 14 by rotating the main tuning dial.
The S-meter will show a single circl )e (
2. Enter ?0?? (E dBMF) with the transceiver tester (SSG).
3. Press the key . The transceiver beeps indicating the new setting
has been stored successfully.
UHF S-meter (FULL) adjustment
1. In the adjustment mode, select channel 15 by rotating the main tuning dial.
The S-meter will show all circles ( )
2. Enter ?+20?dB? (EMF) with the transceiver tester (SSG).
3. Press the key. The transceiver beeps indicating the new setting has
been stored successfully.
VHF wide deviation adjustment
1. In the adjustment mode, select channel 16 by rotating the main tuning dial.
2. Input a 50mVrms, 1kHz signal with your transceiver tester through the
external microphone jack.
3. With the tester, put the transceiver in the transmission mode.
4. Rotate the VR1 on the printed-circuit board of the transceiver until the
deviation is set to 4.5kHz.
VHF narrow deviation adjustment
1. In the adjustment mode, select channel 17 by rotating the main tuning dial.
2. Input a 50mVrms, 1kHz signal with your transceiver tester through the
external microphone jack.
3. With the tester, put the transceiver in the transmission mode.
4. Rotate the VR2 on the printed-circuit board of the transceiver until the
deviation is set to 2.2kHz.
UHF wide deviation adjustment
1. In the adjustment mode, select channel 18 by rotating the main tuning dial.
2. Input a 50mVrms, 1kHz signal with your transceiver tester through the
external microphone jack.
3. With the tester, put the transceiver in the transmission mode.
4. Rotate the VR3 on the printed-circuit board of the transceiver until the
deviation is set to 4.5kHz.
30 |